|
Forum > General stuff
bad hair day
(1/1)
webby2:
One of my printers has been having some issues,, well this is what a bad hair day looks like :)
webby2:
I have been fighting this printer issue for a long time now and I finally found out what the problem was.
My bowden tube broke off a small piece of itself down at the bottom of the heat break,, when I pulled out the tube I could not see into the bottom so I did not know it was there. What seems to of been happening is that broken piece created an increase in resistance as well as created a sort of balloon thing with the filament and stuff,, crazy changing issues.
I finally decided to just replace the entire hot end and it was when I disassembled the old hot end I found the issue.
webby2:
Another melted bowden tube,,
Just because it is blue does not mean it is cafton
Navigation
[0] Message Index |