Picking things back up

[webby2]

Getting a little confused.

I decided to add a pulley on the go-between part that rotates at a 1:1 with the input and output.

I measure that to the output and I get close to a 1:1 value, that is 1000g of pull on the prime mover needs about 900 to 950g on the resistance side, either direction of rotation.

I measure that to the input side and I get a much larger difference, that is close to 1200g for the prime mover needs about 900 to 950g on the resistance side, either direction of rotation.

I was getting a difference one way when measuring between the input and output, then I advanced the output and locked the output in place and now it is close to a 1:1 either direction.

[webby2]

This is odd.

I can move the system with the same force on each side, if I start at the right non sticky spot that is.
I am not taking any notes on this but one way I can keep adding in more prime mover force while maintaining the same resistance force.  This is not the same for all ways I can measure I think but the simple fact that I can do it at all is very odd.

Maybe it is just tweaking the frames and connection belt??? not sure.